|
|
|
|
 |
|
tenx MCU
> 8-bit MCU
> 8-bit MCU
|
|
| |
| TM58PE10 |
|
|
8-Bit Microcontroller
|
|
Data Sheet (*.pdf)
Data Sheet (Sim CH) (*.pdf)
tenx 8-bit MCU table (*.pdf)
|
|
Description:
|
|
Feature:
ROM: 1K x 14bits
RAM: 49 x 8bits / 25 x 8bits
STACK: 4 Levels
I/O ports: 12/16 I/O PAD
(a) 8 Pull High I/O PAD from Port B (PULL-HI resister = 54K (Vdd=5V))
(b) 4 normal I/O PAD from Port A
(c) 4 special I/O PAD from EXT_CLK, RESETB1 (Input only), OSC2 and OSC1 (Only In Advance mode, assign to PA4 ~ PA7)
Timer / counter: 8 bits x (TMR0, TMR1, TMR2), TMR1 and TMR2 can connect be a 16bits x 1 timer
Prescaler: 3 Bits
Five IRQ sources:
- 3 Internal IRQ, when TMR0, TMR1, TMR2 count overflow
- 2 External IRQ: PA0/RESETB0/INT0, PA5/RESETB1/INT1
Watchdog Timer: On chip WDT is based on internal RC oscillator (for WDT used only). Has 4 mode period can be selected: 1ms, 4ms, 8ms, and 16ms. User can extend the WDT overflow period by using prescaler.
Reset mode:
(a) Power-On reset
(b) Low voltage reset
(c) 2 External Pin reset (PA0/RESETB0/INT0, PA5/RESETB1/INT1)
(d) Watchdog timer count overflow reset
Reset Timer: 16ms (5V)
Four external Oscillate modes: RC, LP Crystal, NT Crystal and HS Crystal.
One internal RC oscillator: 4MHz (for user used)
Two operation modes: General mode and Advanced mode
Operation Voltage: 2.2V ~ 5.5V
Instruction set: 79
Wake-up mode: Port B (PB7~PB0) Pin Change wakeup, wake up time can be set by WDTSEL register (23H)
Reset vector: 3FFH
IRQ vector: 3FEH
Package type:
- TM58PE10SS20C
- TM58PE10D18C
- TM58PE10S18C
- TM58PE10D14C
- TM58PE10S14C
|
|
|
|
|
|
|
